Supplies are warranted to be free from defect in material and workmanship for a period of six 6 months for media and twelve 12 months for ribbon from the date of shipment by Godex. Place the right side in first, and then fit the left side. Extended Memory Parts Also See for EZ Programmer’s manual – 25 pages. Power off the printer, press and hold the Feed key. Don’t show me this message again. No other warranties, expressed or implied, are given.
|Date Added:||24 January 2007|
|File Size:||10.1 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Power on the printer after clearing the paper jam, the cutter will return to the correct position automatically. When printing with continuous media, when pressing the Feed key, the printer will feed media out to a certain length. The LED light Ready should turn godex ezpi-1200 goeex power is on. Connect the cable to the parallel port on the printer and godex ezpi-1200 the PC.
Oil Change Reminder Labels and Printers
Got it, continue to print. Open the godex ezpi-1200 cover by pressing the Cover Open Buttons on both sides. Comments to this Manuals Your Name.
Flip close the stripper module. Hold the stripper module and tighten the screws Godex ezpi-1200 gap, black mark, and punch hole sensing.
Check the pins where the memory is to be connected to, then plug the godex ezpi-1200 card onto the mainboard. Data Terminal Equipment Printer. Godex ezpi-1200 the USB cable is connected from PC to the printer, PC will automatically detect the new device and begin the installation process.
No other warranties, expressed or implied, are given. Godex ezpi-1200 the label roll onto the Label Roll Core, Loosen and lift the upper print mechanism by pressing the locking tensons.
GoDEX Thermal Label Printer Ezpi-1200 – Only 1 Left
When printing godex ezpi-1200, pressing the Goddx key, the printer will feed one label at a time; if the label is not sent out in a correct position, then please proceed with the Auto Sensing see page Power on the printer.
When printing, ribbon must be installed to godex ezpi-1200 the print contents onto the media.
Page 17 Select the location of the driver. Page 5 Warranty Exclusions and Conditions Statement The warranties provided above are the only warranties applicable. Select godex ezpi-1200 location of goddex driver.
Chapter godex ezpi-1200 – Printer Installation This printer model has the following print modes: Page 24 Clip in the right side godex ezpi-1200 the cutter module 29 first,then secure the godex ezpi-1200 side. Align the label guides to the lablel edge. To print the manual completely, please, download it. Data Terminal Equipment Printer Page Hold the cutter module and lock it with the two side screws Stripper Parts, Stripper Installation 5.
DB9 female, pin assignment is as follows: Please power off the printer before installing the stripper module.
Godex EZPi and RT700i Labels
Power off the printer, press and hold the Feed key. Take the power cable, godex ezpi-1200 the cable switch to the power socket, and then connect the other end of the cable to the printer power socket.
Don’t godex ezpi-1200 an account?
Place the right side in godex ezpi-1200, and then fit the left side. Secure the PCB pillar onto the mainboard. Supplies are warranted to be free from defect in material and workmanship for ezppi-1200 period of six 6 months for godex ezpi-1200 and twelve 12 months for ribbon from the date of shipment by Godex. Cutter Parts, Cutter Installation one is for stripper installation, another is for cutter installationbefore plug the connector into socket, please check godex ezpi-1200 pin first.