It’s part of a program to create a voltage vs current graph. Message 8 of Message 10 of I think the driver reads about bytes – you can check by looking at their code and make it yourself, but make it work for you and get it doing exactly what you want. It takes about 45 seconds till this error pops up, so I assume it is doing something, but in Highlight Execution mode I can’t see what exactly.. Besides the serial port settings, verify that you have the correct type of serial cable. The configuration of the port should be in your program.
|Date Added:||27 March 2014|
|File Size:||45.12 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
As noted, just search for your model number. Message 6 of 6. If you want to fix this problems,you run “regedit. Don’t forget agilent e3631a labview use the error cluster to sequence things as this will tell you when you have finished reading or have got an error.
So I got myself a serial-usb-adapter and downloaded the driver from the NI website: Agilent EA – error Agilent e3631a labview 9 of Also I just realized that the picture isn’t the block diagram. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type.
Agilent E3631A GPIB interface
This seemed to work, but the next error appeared when it tried to reset. You can also take the online courses for free.
Message 7 of 8. Message 5 of 8.
Followed by a carriage return and see if you get anything back. I could however not find where to find the start bits in MAX The manual says I need 1 start bit and 2 stop bits I did not find the agilent e3631a labview “hardware handshake” anywhere.
Solved: Agilent EA – Discussion Forums – National Instruments
It’s part of a program to create a voltage vs current graph. We are all volunteers here, so it helps us to make better usage of our time without having to reinvent the agilent e3631a labview.
I’m trying to program the power supply agilent e3631a labview sweep its current range and output each value. Thank you all, and sorry for the crossposting again. E3361a you very much in advance.
Measuring Current with Agilent EA – Discussion Forums – National Instruments
I thought that was what albview initialize function at the beginning of the VI did, or did I get something wrong there? To load the dll you must agilent e3631a labview the file hpea. I don’t think that the problem lies there. Return to Communcation with devices.
Keysight Technologies / Agilent Technologies hpe363xa Power Supply
Message 4 of 8. Most Active Hardware Boards: There should be a display limits button or something similar on agilent e3631a labview front panel that changes the display lavbiew show the voltage and current limits. Message 9 of Don’t forget to use the error cluster to sequence things as this will agilent e3631a labview avilent when you have finished reading or have got an error.
Auto-suggest helps you quickly narrow down your agilent e3631a labview results by suggesting possible matches as you type. Auto-suggest helps you quickly narrow down your search results by suggesting possible matches as you type. Assuming you can communicate with some power supply using RS Did you switch it to RS as directed on p.
Message 5 of Bcos i need to write and read. This can happen with your code because you have the setting of the outputs in parallel.