I was really looking forward to trying out Win 8 with the touch screen. Tell us about your experience with our site. Despite the software reported no devices found, the hardware still shows up as installed and working properly in Device Manager; I have three entries under Digitizers: Sunday, September 25, 6: I went back into the folder where I extracted the driver and ran the DPInst manually.
|Date Added:||21 March 2005|
|File Size:||55.73 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
I’m going to keep messing with it Is your reply saying that the Surface drivers will work on the Dell?
General OS questions Locked. Working drivers at least.
n trig duosense bulk If not, will the Windows 8 N-trig drivers work with Windows 10 if I track them down This also shows why Microsoft really needs to work with N-Trig nulk get a Windows 8 n trig duosense bulk dosense installer released, because it is a slightly painful process at this point.
Despite the software reported no devices found, the hardware still shows up as installed and working properly in Device Manager; I have three entries under Digitizers: Maybe you’re blocking the light sensor or something when you touch the screen?
I was really looking forward to trying out Win 8 with the n trig duosense bulk screen. I have been troubleshooting and trying to solve the problem for the past week to no avail. I do have XT2 atleast now pen and touch is working.
TOSHIBA Satellite U/01C N-Trig DuoSense – TOSHIBA FORUM
Thank you for posting your query duosensr Microsoft Community. Proposed as answer by PerryReed Sunday, September 18, I can still use touch only in a very few places.
Touch now appears to be working well on my tx2. The solution for me, and many others initially I believe, was to change the screen-refresh rate in the Intel-Graphics control panel, from 40p Hz to 60p Hz.
LesCarterIreland Replied on January 23, Thursday, September n trig duosense bulk, 7: I booted back into Windows 7 just to make sure that duosenxe multi-touch firmware was still working and it continues work just fine in Win 7. Monday, September 19, 4: Is anybody else facing this issue? Go to the Bhlk Folder check the temp folder inside and look for the NTRIG install log Open it Check for the folder that contains the unpacked driver browse for it n trig duosense bulk copy all the contents to another place go to the device manager, rightclick on duosense and when prompted indicate the place where you left the drivers.
By continuing to browse this site, you agree to this use.
N-trig duo sense and wintab drivers for windows 8 and/or windows – Microsoft Community
Well, after manually extracting the drivers from the. Sign in to bbulk. I have contacted N-Trig but have not yet got a response. Help us improve MSDN.
Should I try a bit installation? Also, these drivers were apparently older than those that came prebundled with the computer 2.
But in the end I solved this in W10 by running a little task-bar application, “Tray Touch Toggle”, n trig duosense bulk allows you to turn the touch screen off and on. LesCarterIreland Replied on January 31, Tuesday, September 20, 7: I have also tried dpInst and when i run it it says N-Trig is ready to use and drivers are successfully installed.
I still only have one touch point and still cannot calibrate or dusoense multitouch under the software still get the “No devices found” window. Although I don’t use Photoshop, so not sure on that one. Tell us about your experience with our site.