About the only thing good I can say about this printer is that it prints out great in color on regular paper and does it fairly fast – but “warm-up” time is slow and noisy. LD1 2 Confirm sensor input Refer to next para- graph. In particular, a problem in the laser unit, fusing unit, developing, or image transfer section will cause a momentary stop. Remove the timing sensor Timing sensor 1. Does the rack motor M3 operate during print- ing? Sorry, we’re having trouble showing recommendations right now. No Ensure the connection of the connector PJ22A is secure.
|Date Added:||8 September 2006|
|File Size:||32.87 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
konica, minolta, magicolor, 2200, toner, cartridges, minolta, qms, 2200, toner
There is 1 connector. Is there a tab on the one-way clutch for the multi- purpose tray take-up roller? Remove the rear cover. During power supply fan motor error Stopped 3. If the optional lower tray is added sheetsthe paper take-up system becomes a three-way system. More details on Cleaning roller Cleans the coating roller 5. Be careful when removing this shaft because it also serves to secure the spring loaded transfer roller housing. Carefully listen to and understand the user’s description of the problem.
Does the prism for the OHP sensor have paper dust or particles on it? LED light passage port Light passing through this port is used to determine when there is no toner.
Remove 2 screws for the rack lock lever and remove it.
Drive Transmission Gear Drive motors are not installed in this tray. Remove PU1 together with magicoolr mounting plate. Pick-up roller Feeds paper to the duplex unit for magiclor on the back-side. Paper empty sensor 9 Paper exit roller Remove the control panel cover. This pushes down the section shown as “A” in the illustration below, releasing the image transfer belt cleaner from the image transfer belt. Others Replace PWB-A Detection of image transfer roller pressure release position is performed during the pressure and release operations before and after paper image transfer.
QMS Magicolor Toner Cartridges
Multipurpose tray 8 Fusing unit Does the control panel display “Ready” or “Power Save” mode? Remove the 2 laser unit connectors from the PWB-A circuit board and pull them out from the harness duct.
Keep clothing and other objects away from moving parts such as pulleys and gears. This printer uses an invisible laser beam.
Ordinary plain paper prevents the light from entering the photo sensor, and it is there- fore not detected as OHP film. Warm-up completed Initialization completed B C. Registered trademarks are reg- istered in the United States Patent and Trademark Office; some trademarks may also be registered in other countries. I had one issue with it not printing when it went into energy save mode. Always handle the circuit board by its insulated parts so that you do not touch the terminals or soldered sections.
Remove the motor cover Cover hook 1. Yes Replace the HV2 high voltage cir- cuit board. Paper size switch Detects the size of the paper in the cassette.
This problem is eliminated with the updated drivers which are downloadable from the website. Remove the controller cover.
All I’ve seen in the store are test-prints and who knows how misleading those are; our Minolta test print looked fine too. Problem Check Result Corrective action When there is paper in the printer.