This tool has also managed to detect the barcode of all my loaded media. I’ve run all the patches for 11d, updated firware of the meduim changer and the tape drive. Start the robotic library, and verify that the device initializes correctly If I’m still having troubles I will call to open a support ticket. Same thing for the folder location The old 10d location is C:
|Date Added:||25 December 2009|
|File Size:||11.66 Mb|
|Operating Systems:||Windows NT/2000/XP/2003/2003/7/8/10 MacOS 10/X|
|Price:||Free* [*Free Regsitration Required]|
Sounds like the medium changer problem got solved and now the tape drive itself is acting up. The G2 Autoloader may have been recently added and may not be in an older version. I’d like to thank you both Fazrul and Lou Buffetta for your help and attention to details.
HP Ultrium-2 SCSI Sequential Tape Device Free Driver Download (Official)
You’ve reached the right place. Click Next when the Welcome screen displays.
Complete the wizard and reboot the system BTW, my autoloader is connected to backup hp ultrium 2-scsi scsi sequential device using the top SCSI connector while the lower connector is installed with a terminator. It is important that you have the most recent device drivers for your version of BE. Anyway, thanks a lot Lou. Storage Device Configuration Error. I’ll be looking for updated drivers for my SCSI card, uultrium.
HP Ultrium-1 SCSI Sequential Tape Device Free Driver Download (Official)
When U,trium uninstalled and reinstalled BackupExec, I removed all applications that were installed during the BE installation a fresh installation was done. SingleBlock 1ScsiPass 1 Error 2: Same thing for the folder location The old 10d location is C: When you changed the cable and terminator, did it effect termination of the tape drive itself? Any advise on how to proceed from here?
When the dcsi is booting up, this is the SCSI information shown: I had the SCSI cable attached to the upper port in the rear dcsi the autoloader and the terminator was on hp ultrium 2-scsi scsi sequential device lower port, I switched them.
Let’s see how Backup Exec is recognizing the library. BE still only sees the tape drive and one media within the autoloader. When I try to manually add a device, it only detects the tape drive. This is how the autoloader manual states. When Autoloader and Server was booted up, Windows detected autoloader and the tape drive but it was “unknown device”. If the steps below doesn’t resolve the problem, hp ultrium 2-scsi scsi sequential device best to call in and work with a support tech.
You’ve been outstanding to work with, thank you again! I have changed the driver back to Unknown Media Changer, and both the drives are using the Symantec drivers. This is used mainly by the Windows backup utility and competes with us for control of the drivers. I am currently using BE.
I have even tried uninstalling Backupexec and reinstalling uninstall, reboot, install, reboot but the autoloader is still not detected by BackupExec.
RSM cannot manage library Tape0.
HP Ultrium 2-SCSI SCSI Sequential Device driver free download for windows – HP – ProLiant DL G4
How do I go about getting the BackupExec to “see” the autoloader? I’ve run all the patches hp ultrium 2-scsi scsi sequential device 11d, updated firware of the meduim changer and the tape drive. Problems were encountered during the configuration of your storage devices.
I’ve looking for a driver of the meduim changer seuential on the sysmatec site, but no luck. In Windows Service stop and disable Removable Storage service.